Home Class List Class Activities Jewelry Gallery Events How-To-Make... Torch Manual

I recently made a prototype ring as an experiment. The ring is based on a design by Steve Macfie, of Orlando, FL.

Here is a black-and-white version of the finished ring.

I made three samples in copper, before this one in silver, to work out the fabrication and sequencing details.
Here are some of the parts that I prepared in advance to be put on the ring. The 'gold' disk is actually sterling silver, imprinted with a pattern through the rolling mill, then surfaced with thick gold foil (keum boo technique).

Sadly, I forgot to take photos during the construction of the ring, but I wasn't sure it would work until this stage.
At this point, everything has been soldered on with Hard solder. There are seven separate solder joins so far! This includes re-sizing the ring, with its associated solder join at the bottom of the shank.

Besides testing my skills, it gives me more leeway in adding the rest of the decorations.

There were four more solder operations before it was finished, and nothing dropped off or came apart.

The design as drawn had really lovely wings to go on the shoulder and down the shank, but between my own drawing skills and the space available, this is what I came up with.
I cut these out of 26g sheet, with a 6/0 blade, hanging on by my fingernails! They are really tiny.
Here is a test-fit before soldering, seen from the top, while being held in tweezers. I had to chase one around my bench, after it 'flew' off.
Finished ring, with insert (temporary adhesive), liver of sulfur to make the wings and other decoration stand out.
View from the top. The 24k gold foil makes a nice contrast with the polished silver bezel.
Profile of the ring. It hugs the finger closely, to avoid having it bang around or snag on things. I considered having the wings flare out from the ring a bit, but decided against it - I've repaired too many rings that had (used to have) pretty details.
Interior view, with liver of sulfur patina still evident.

I elected to not line the ring for a number of reasons. It saves weight/cost; allows the knuckle to fit through without pain while still allowing a close fit on the finger; and alleviates the nightmare of collected grime that is the bane of hollow rings.